PET probe manifesto
List of hardware components required to assemble the PET probe setup as used at University of Michigan 2008-2013.
Silicon:
- 2 Silicon 1 mm detectors and hybrids (NC)
- 8-16 Flat 50 0.5 mm spaced cables (NC)
- 4-8 Daughter cards B770H, schematic (NC)
- 4-8 Enrico's VATAIB boards (NC)
- 4-8 50 pin flat cable (100 mil connectors) (NC)
- 4-8 Enrico's VATAVME boards (NC)
- 1 VME crate with 15 slots (NC)
- VME power supplies (NC)
- 1 VME controller Struck SIS 3300 (NC, AS)
- 1 Optical cable (NC, AS)
- 1 PCI optical controller Struck SIS 1100 (NC, AS)
- 1 low noise HV bias for sensors (HK?)
- 1-2 ASIC power supplies with preset voltages (NC)
- 20-40 LEMO cables
- 20 (?) LEMO to BNC
- 2 MADDAQ boards to replace 8 VATAIB/VME modules
BGO:
- 24 BGO modules (NC)
- 24 4 channel BGO cards + spares (NC)
- 24 power supply cables (various lengths) (NC)
- 2 BGO power supplies (+/- 15V or +/- 5V) (NC)
- 1 HV supply for BGO (NC)
- 8 arc gantries (NC)
- 48 BNC cables (trigger/signal per box) (NC)
- 1 TTL to LVDS converter for triggers (NC)
- 3 analog fan-in for signals (NC)
- 1 CAEN V1495 logic unit (NC)
- 3 CAEN V785 ADC units (NC)
- 3 34 pin flat cables (NC)
- 2 V1495 flat cables, 32 pins (NC)
General
- Support table (6' by 4') with 1" hole grid (HK)
- Collimator tower with vertically adjustable table and rotarty table (NC)
- VELMEX motor controller w/1 set of cables (NC)
- RS232 cable for VELMEX controller (NC)
- Cable holders (NC)
- A fine screwdriver for setting BGO/VME voltages (NC)
- Jaszczak phantom (NC)
- desktop running Linux w/ RS232 port and empty PCI slot and additional network card (for MADDAQ) (NC, HK, AS)
- a network switch (for MADDAQ, can be old) (?)
- cabled network (HK)
- point sources (HK)
- oscilloscope w/probes (needn't be fast) (HK)